Virtual DTM (PACTware) Training, December 15-16, 2020 

This virtual class educates end-users on commissioning, troubleshooting, calibrating, and performing data collects on VEGA instruments. Students will be able to configure a 4... 20mA VEGA radar sensor, set up the 0% and 100% points, configure the PLICSCOM display, set up the failure mode, optimize the sensor for the application, and suppress false signals.

Register Now!

If paying by purchase order, please use promo code PAYINGBYPO and click apply.

Send all purchase orders directly to r.madden@vega.com.

Topics:

Fundamentals

• Choosing the right instrument
• Advantages and limitations
• Basic principles and definitions of radar and guided wave radar
• Theory of operation
• Dielectric constants
• Installation of radar and guided wave radar
• Uses of stilling wells, bridles, and polarization
• Power requirements
• Wiring options and limitations

Overfill Safety

VEGA DTM/Firmware (Current Release)

• Enhanced features
• PACTware including an introduction, configurations, adjustments, echo curve analysis, and false signal suppression

Troubleshooting with VEGA DTM

• Sensor optimization
• Service options
• Configurations
• Instrument diagnostics

VEGA Americas, Inc. reserves the right to cancel a class due to low enrollment.

VEGA Americas, Inc. is a manufacturer and seller of measurement technology and products; purchase of VEGA products is not required to complete the course.