When

Wednesday, December 7, 2022 from 4:30 PM to 6:30 PM EST

Add to Calendar

Where

Winstel Controls - Tri-County
10126 Transportation Way
Cincinnati, OH 45246



Driving Directions

Contact

Larry Harmon
Winstel Controls
larryh@winstelcontrols.com
513-512-7552 (Cell)
Presents:    
  Centrifugal Pump Basics
 

Winstel Controls is pleased to offer this 2-hour session on Centrifugal Pump Basics. This course, presented by Eric Meyer of Blackmore and Glunt, is designed to provide a basic knowledge on hydronic centrifugal pump sizing, pump accessories and teardown of a centrifugal pump.  Blackmore and Gunt is the manufacturer's representative for Bell & Gossett.

This 2-hour Seminar will include:

  • How to Size Pumps for Flow and Pump Head for Open and Closed systems
  • How Pump curve information is used for proper selection
  • Troubleshooting a Centrifugal Pump

Continuing Education Credits:

  • 2 Hours OH – HV, HY, PL, RE - Course #3860042
  • 2 Hours KY - HVAC Masters & Journeyman Approved

A light dinner, dessert and beverages will be served. This class will take place in our training room that can accommodate only a limited number of attendees. Please register early. Although there is no charge for this class, registration is required, and may be further limited at Winstel Controls’ discretion.

NOTE: You must have an email address to register online.  The email address you use here to register should also be used when logging in for the class.